FP2 Basic Hydraulics 1

If a cylinder has restricted flow into the cap end port and unrestricted flow out of its cap end port is considered a _____________ application.

A flow control valve is made up of a __________ and a ___________ in __________.

A pressure control valve which detects the pressure past the valve, is normally open, and vents excess pressure to tank is a ___________________.

Draw a bi-directional hydraulic motor which has a needle valve attached to one of its lines, allowing speed control.

A valve that allows flow in one direction but not the other is a ________ valve.

The speed of a cylinder is dependent on the _________ of the hydraulic supply.

Are liquids a fluid?

Hydraulics typically use ______________ speed control.

__________ is created when there is resistance to flow in a fluid power system.

A ___________ valve is also referred to as a sequencing valve.