5 minutes Craft

Step One: Place the bar pull handle onto the cutting board close to the edge and make sure it is centered width-wise. Use a measuring tape to measure the distance from the edges of the cutting board to the point where you will be placing the screws that attach the handle. Write down this measurement.

Tip: Place a piece of scrap wood beneath the cutting board when drilling to avoid damaging your work surface

 Step Two: Remove the handle and mark the points you measured in the previous step. Before drilling, make sure you measure the distance between the two marks to verify that it matches the distance of the attachment points on your actual handle.

Step Three: After triple checking your measurements against the handle, drill into the cutting board with a drill bit that matches or slightly exceeds the size of screws for your handles.